126428, Some progress with the 2.2L Posted by eclipse982nrRST, Dec-31-69 06:00 PM
Got some extra time to start working on the project again this week. I was wanting to -16an upper and lower radiator hoses, and I want the thermostat housing about an inch lower then how it sits from the factory, so as you can see below, I modified the housing how I wanted it. The Coolant temp sensors for both MS and my ProSport gauge will have bungs welded into the radiator along the top.
Not much other stuff done yet, got the manifold and turbo mounted back on. Also, added 10mm studs for the exhaust manifold. Got the turbo drain ran to the oil pan, finished painting the intercooler piping and mounted the BOV. Made a cam sensor block off plate and welded in some good old skateboard bearings for shifter bushings.
|