Both sides of the story are completely valid. IF the Cranes were available, those would have gone into my new cylinder head anyway. I was looking for something that would get me into the 15s solidly for now.

They are cheap and do the job right. All you have to do is correctly shim your lifters. You are not going to get any extra wear from doing this on the cam lobes, liftersor rocker arms. I looked. Everything is pretty.

I don't really feel like waiting for Crower to get our cams ready. We're already 2 years behind the curve of the Honda/Acura cams and we'll just fall farther behind unless one of the manufacturers steps up and just get's the job done. If you go out to the Crower site, there are supposedly grinds available right now. If you look on Howell's site, they have 7 more grinds available to them than we will have.

Sorry, but I'm starting to get pissed off by this.