Go back to previous topic | Forum name | Manual Trans - NV-T350 | Topic subject | RE: AT/MT swap almost done, except for this little switch... | Topic URL | http://forums.2gnt.com/dcboard.php?az=show_topic&forum=34&topic_id=9058&mesg_id=9060 |
9060, RE: AT/MT swap almost done, except for this little switch... Posted by dwn, Dec-31-69 06:00 PM
Will do. I was thrown a bit by the Mitsubishi electrical manual where it very clearly shows the trans-axle range connector as a 10 pin.(A108)on page 194. After looking at your photos it was obviously not the case for the 95. The park/neutral safety switch conn. and the trans/position switch conn.in my vehicle are identical to the ones in your photos. I'll hook them up tomorrow and test it out. If it's good, then I'll remove the auto ECM and install the manual ECM. That way I know if it's crapped without second guessing my previous work. Thanks for a quick response, and an excellent article.
| |