Ok so my shits are getting slack and i can see the rubber at the end of the cables that attach to the trans are worn to death... And i have heard and searshed about them but didnt find much to my info... I even searched sites to see if they sell any but all i find is shifter bushings kit which is the shifter it self bushings, i think... And i find cable bearing for the 4g63 trans but not our trans... Or are they the same?
Anyone have anything like this installed? and if so have any pics of what it looks like?

shazaam http://cgi.ebay.com/Tsunami-Abec-7-Skateboard-Bearings-Set-of-8_W0QQitemZ360193999611QQcmdZViewItemQQptZLH_DefaultDomain_0?hash=item53dd3c42fb&_trksid=p3286.c0.m14

Originally posted by MITSUracer123
Ok so my shits are getting slack and i can see the rubber at the end

Sounds painful. You may not want to take it up the.......nevermind :P

Originally posted by MITSUracer123... And i find cable bearing for the 4g63 trans but not our trans... Or are they the same? Anyone have anything like this installed? and if so have any pics of what it looks like?

I use the same bearings for 1g turbo as I do for our cars (hell I've used them on 2g's also). I basically have some extra rollerblade bearings from when I upgraded my skates. I use them when the eyelet rubber gets worn. Clean up the interior of the eyelet and grease it up. I use a couple of pieces of wood on each side, and clamps or even visegrips to press it in.

www.AMSperformance.com sells a set of alumin ones that i have in my car. They are awsome and fit great. They are for the 4g63 but fit in ours.

lol Ok thanx for the help. I was seeing some stuff on MachV site but its mostly 4g63 crap.

Just go to your local skate shop and buy the cheapest bearings that they have.

http://www.boogerracing.com/boogerbushings.html