Just like the title says. I've never done this before and I'm trying to figure out if it just simply slides on, or does it clip in a certain way? Thanks for any help.

It slides on, but there are two small tabs that must go behind the TOB lever fork. Make sure you don't break them. If you put it on incorrectly or break those tabs then you will get a rattle when the clutch pedal is not being pressed on. It's hard to visualize so I use a little mirror to double check that the tabs are placed correctly. Also make sure you have auto grease on the bearing.

Thanks alot for the help. Ok I wasn't sure if it was just the tabs that hold it in place, cause it seams like it could come loose pretty easy even with the tabs in place, though I broke 1 of the tabs, so just to be safe I ordered a new bearing. Yah I don't have any high temp grease, so I might get some tomorrow, cause it sounds like normal grease doesn't work.

Heh heh, yeah, its sloppy. Also, the breakage is not uncommon. Good luck.

Thanks for the help. I'll let you know how it goes tomorrow.