Go back to previous topic
Forum nameManual Trans - NV-T350
Topic subject3rd gear bogs out hardcore?
Topic URLhttp://forums.2gnt.com/dcboard.php?az=show_topic&forum=34&topic_id=7609
7609, 3rd gear bogs out hardcore?
Posted by rshissler, Dec-31-69 06:00 PM
So i finally got my car running and now driving it. 1st and 2nd gear pull hardcore and then when i hit 3rd it bogs bbbbaaaadddd, then 4th and 5th pull. Also when shifting extremly fast (drag racing like) the car wont hit 3rd and feels like its just sliding against something. Like the shifter will slide inbetween 1st and 5th but wont go into 3rd. The kid before me that had the car installed a short shifter (unknown brand, Its purple and chrome). Could it be possible that he messed something up and that when i shift into 3rd its catching 5th instead? Or is there something wrong with my 3rd gear in the tranny to causing it to bog the car? I know im not hitting 5th by mistake cuz when i shift into 4th i just pull straight back and its in 4th.
7610, RE: 3rd gear bogs out hardcore?
Posted by rshissler, Dec-31-69 06:00 PM
forgot to add that it worked fine the other day when i was shifting nice and slow. I ordered a shift kit from Mach V or whatever the site is. Hoping that this is the problem.
7650, RE: 3rd gear bogs out hardcore?
Posted by halfasss101, Dec-31-69 06:00 PM
my 3rd gear used to do that. There are 2 sleeve type deals under the radio on the cables and one of mine was lose and just kind of flopping around in there and wouldn't go into third but every other gear was fine. Fixed that and it was fine. Which shift kit did you buy from mach v? The shifter cable stiffeners that go on the the cables on top of the tranny or the ones that go on the shifter plate under the center console? My review of both, the shift kit that goes on the shifter plate under the console:waste of money, i noticed no difference. The cable stiffeners that go on the cables at the tranny, waste of money but make a difference in the stiffness. Would save money by going to BIG 5 or someplace that sells skateboard bearings and have someone tig weld 2 of them together or not. doesn't matter. the shitty tig welds on mine broke during installation so i just put them in anyway. 10 bucks for a pack of ten bearings i think. You'll have extras, but its still better than paying over 30 bucks shipped to your door. Also, my short shifter has purple piece on it too and its chrome. It's a Megan Racing shifter or maybe a knock-off ebay one. I think thats the only one with the purple though.
I generated this page in 0.0086479187011719 seconds, executing 7 queries.