whats up guys, next week ill be ordering a SBC from andy and im just curious what all i will need for the install? Tools of course, but are there any gaskets or seals i should go pick up?

rear main, if you haven't replaced it in a while. Might as well tackle it since the tranny will be down. As for the clutch, no seals, gaskets are required.

If it is non-modular, a clutch disk alignment tool would be good. Maybe a quart of trans fluid to replace whatever runs out when you pop the axles out.

Corbin
'95 ESI-T

Now with more power and fewer leaks



Gimme fuel...Gimme fire...Gimme that which I desire

thanks guys, ill look into the rear main. Right now im struggling getting the exhaust bolts off. their so rusted their not even in the shape of a bolt anymore. it is HORRIBLE. ha i have a feeling this car is going to be on jack stands for awhile!

axle seals