Go back to previous topic
Forum nameManual Trans - NV-T350
Topic subjectNew linkage bushings
Topic URLhttps://forums.2gnt.com/dcboard.php?az=show_topic&forum=i34&topic_id=669
669, New linkage bushings
Posted by daltah, May-12-03 02:33 PM
I dont have one of the bushings on one of my linkage cables.The one that connects to the tranny.Can i buy a new and if so where and how much?Also how hard would it be to take it off and put the new bushing in.Is their any harm in their not being a bushing their?
678, RE: New linkage bushings
Posted by Michael_97RS, May-13-03 05:50 AM
The shufting will be extremely sloppy with a bushing an dprobably won't even engage into gear. the problem is, the dealer will want to sell you the whole linkage and not a bushing separate.

Try a boneyard or http://www.allmitsubishi.com and see if you can get just a bushing in good condition.



15.9 @ 86.7mph

Injen CAI, 55mm TB, P&P Intake, Crower Cams, Hooker Header, ERT/Catco Cat, GS-T Muffler, AFX UDP, Crane Ign Amp, S-AFC
687, RE: New linkage bushings
Posted by daltah, May-13-03 03:18 PM
Their is no where else to buy the bushings?Also is their something else i could use like jbweld?
703, RE: New linkage bushings
Posted by juggalo, May-15-03 11:55 AM
couldn't you just use washers?
707, RE: New linkage bushings
Posted by daltah, May-15-03 02:35 PM
how could i use washer for bushings?