Hey guys, i wonder if you guys could help me out?

THE PROBLEM: i cant engage the gear, all the lines are fine, and the clutch is nice and hard..

last week i hit a bump and the gear wouldnt go in, so i inspect everything, and the svale cylinder rod, was bent, so i got a new rod, and it was fix, and then today it started again, i took off the rod and it wanst bent, so i put the slave cylinder back on and the gears worked, but the clutch would have to be adjusted all the way out, and then i pull into the gas station and shut the car off and got gas, then started the car and it stop going into gear.....


I'm really baffeled by this ...can anyone help me?
do you think i need to get a new slave cylinder?

the fluid level is fine
the fork doesnt look broken
the clutch is new....

but the throw out bearing make a ticking niose, but idk if that the prob.

this is the third time it has stop working, in 1 month, i dk what going on

Try bleeding the clutch, Will it go into gear with the car off?

yes, they do


i just dropped the tranny, ill look into it tomarrow..