| Go back to previous topic |
| Forum name | Manual Trans - NV-T350 |
| Topic subject | I need help getting the... |
| Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i34&topic_id=6520 |
6520, I need help getting the...
Posted by 505racer, Jul-06-07 10:10 PM
... whole assemply out of the transmission how does it come out...
i sat there and fought with it for about three hours and it would not come out...
i took out the guide for the oil and that is about it...
any suggestions or ideas? TIA
|
6521, RE: I need help getting the...
Posted by bullettdsm, Jul-07-07 11:31 AM
Minimum 20 ton press with the proper supporting jigs. Then get ready for a boom if/when she breaks loose. It's a strong press fit into the bearings (I presume you are talking about the whole shaft assemblies).
You sure you want to do that?
|
6522, RE: I need help getting the...
Posted by 505racer, Jul-07-07 10:17 PM
Originally posted by bullettdsm
Minimum 20 ton press with the proper supporting jigs. Then get ready for a boom if/when she breaks loose. It's a strong press fit into the bearings (I presume you are talking about the whole shaft assemblies). You sure you want to do that?
ya that is waht i was talking about... my grandpa got them out...
i think it was kinda stupid he used the acetylene torch.. and burnt the bearing off...
where is the best cheapest place to buy the whole rebuild kit to these transmission...
any other insight what be greatly appreciated
|
6542, RE: I need help getting the...
Posted by 2GeclipseRS, Jul-16-07 03:14 PM
Originally posted by 505racer i think it was kinda stupid he used the acetylene torch.. and burnt the bearing off...
YOU THINK!!!
|