hey all I have been looking for 2 days now I cant find the write up on a clutch install Its funny i can see a post in things we have seen b4 but cant click on it can someone post a link please. thanks again its for a non modular If there are more than one

Are you looking for a howto on a non-modular setup?

yep

Well first you need the bolts that hold the pressure plate to the flywheel and the flywheel to th crank. I would suggest using some blue loctite to ensure the bolts do not back out. I picked up the pressure plate to flywheel bolts at an industrial screw supply house. The flywheel to the crank I purchased from a Dodge dealership since the industrial place didn't have anything that finely threaded in the size I needed. Make sure the bolts are a Class 10.9 or higher. I think mine are 12.9. Bolt sizes are here.

http://forums.2gnt.com/dcboard.php?az=show_topic&forum=34&topic_id=62&mode=full

Next up you need a nonmodular clutch setup for a 95 Dodge Neon. I used this as an opportunity to grab a lightweight flywheel from Fidanza.

Next up, bolt the flywheel to the crank. I think the torque specs are 35 ft/lbs. Use the included pilot bushing, some red loctite and insert the bushing into the crank.

There will be a clutch alignment tool with the nonmodular clutch kit. I let the clutch hang on the alignment tool while I bolted the pressure plate up.

Stab the transmission to the motor and you are done.

Moving to transmission....