| Go back to previous topic |
| Forum name | Manual Trans - NV-T350 |
| Topic subject | The Easy Way to Install a New TOB |
| Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i34&topic_id=5647 |
5647, The Easy Way to Install a New TOB
Posted by WickedESi, Aug-17-06 06:03 PM
I've heard about a lot of people breaking the little tabs on their new TOB's trying to install it.
Just pop the TOB fork off, grease it where needed, slide the new TOB onto the fork, and slide the TOB/fork assembly onto the tranny. Easy.
|
5648, RE: The Easy Way to Install a New TOB
Posted by Chamuko, Aug-18-06 09:47 AM
I thought that was the standard procedure?
|
5650, RE: The Easy Way to Install a New TOB
Posted by omgitsjames08, Aug-20-06 10:35 AM
do you have to pull your tranny to replace it?
Newb Question
|
5655, RE: The Easy Way to Install a New TOB
Posted by WickedESi, Aug-22-06 07:18 AM
Originally posted by Chamuko
I thought that was the standard procedure?
I'm sure it is, but I've always heard of people on here using a screw driver to push out the tabs to pull it off and then breaking the tabs.
Originally posted by omgitsjames08
do you have to pull your tranny to replace it? Newb Question
Yes
|
5661, RE: The Easy Way to Install a New TOB
Posted by andy_sbclutch, Aug-23-06 09:56 AM
Originally posted by WickedESiOriginally posted by Chamuko I thought that was the standard procedure? I'm sure it is, but I've always heard of people on here using a screw driver to push out the tabs to pull it off and then breaking the tabs. Originally posted by omgitsjames08 do you have to pull your tranny to replace it? Newb Question Yes Several people have sent the TOB back to me with broken tabs.
Pull and slide.
|
5672, RE: The Easy Way to Install a New TOB
Posted by totaleklipse97, Aug-23-06 05:33 PM
I know I have come across this problem more times than I have cared to. Andy, Is there anyway SBClutch could design a better TOB for us. I live about 10 minutes away from you guys and I could swing a TOB over for you guys to look at and see. Just send me a message if this is possible.
|
6000, RE: The Easy Way to Install a New TOB
Posted by ronjeremy525, Jan-04-07 06:44 AM
When i installed a new clutch and throwout bearing i had no problem. i used my haynes manual. described in detail what to do. was a sinch. went through about 4 cans of brake cleaner though. clutch works great, and no more rattling TOB.
|