When i first get into the car the pedals falls to the floor...but when you pump it a bit...it works fine. Whats the deal? Slave cylinder? any ides please help!

I just checked the next post and it says to bleend the tranny fluid lines...anyone know how

no, its bleed the clutch slave line. if you dont know where the slave clynder is, then take it somewhere that knows where it is.

I have a master cylinder leaking before. My clutch can't move up itself.

Not sure if it's the same problem.

Check for leaking !

yeah, it sounds like a leak somewhere. look up under the dash behind where the MC is, you might find it running down the inside of the car.

my master cylinder was leaking a couple weeks ago, and i lost all pedal pressure, and i had to pump it, etc. just check for leaks, if it is the MC replace it and bleed the clutch lines, its not too hard.

if you need any help on replacing the master cylinder just IM me.

The slave cylinder bleeder valve is the same size as the brake bleeders, I would recomend replacing it with a speed bleeder, its much easier and more efficient than doing it manually. I had a bleeder valve go bad on me before and it was leaking fluid very slowly, look at the slave cylinder and see if you can spot any fluid coming out.