Can anyone give me the OEM part number for the PT Cruiser clutch? Also any advice or experience with it? I my just go with a stock replacement. I am sick of my SPEC stage 4.

Andy

PM Driggs DR1665v2 is his SN now.

Never mind, It is on its way from Bob Kise. Tonight I am going to install a new master cylinder in hopes of fixing it. I am not feeling too good about it though. I hate my damned car right now! I am close to selling the POS and getting a good car, ie NOT A DSM!!!

Andy

MonteSS86@hotmail.com

Originally posted by Ozzmosis86
Never mind, It is on its way from Bob Kise. Tonight I am going to install a new master cylinder in hopes of fixing it. I am not feeling too good about it though. I hate my damned car right now! I am close to selling the POS and getting a good car, ie NOT A DSM!!! Andy MonteSS86@hotmail.com

lol after you do that call up briggs and stratton and see if they need any piston designers...lol

Justy giving ya hard time...hang in there and remember "the sun doesnt shine up the same hogs ass everyday"

Terry

96 Eagle Talon ESI....Daily driver

97 Eclipse.........

Thanks for the encouragement! We are tearing into my roommate's car, the one who bought your pistons, rods, block, to replace his clutch and redo his rear main that is leaking. After that I think we are going to tear into replacing my clutch. I found a place here in town that would do it for me, but they would charge me $400. That is only for labor, I have to provide the parts. It may be a long weekend!

Replacing 2 clutches, 1 rear main seal, and potentially pulling and rebuilding another 420A. Whew, is there enough time!!! Anyone in N. Indiana interested in helping?!?!?


Andy

MonteSS86@hotmail.com