| Go back to previous topic | | Forum name | Manual Trans - NV-T350 | | Topic subject | Sound from tranny | | Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i34&topic_id=2844 |
2844, Sound from tranny
Posted by Jasvb TS2K2, May-26-04 06:26 PM
I need some help with a wierd issue. I had a tranny swap. After the swap it has not been right. It's a stock tranny but I get this thump in 1st and 2nd gear but not anymore after that. No issues on the highway. And it doesn't happen all the time. If I come to a stop and don't make a full stop and accelerate again it does it. If I am in the gear and accelerate it happens. If I am stopped, rev above 2k and slip in 1st gear, it won't do it. I know it's not a driver thing cause I'm selling the car and it has happend to all the potential buyers that drive it. And it's been a major issue to not been able to sell it. I had the work done at a shop but not the dealer. Should I seriously talk to them about it? The stock tranny, clutch, flywheel I got was used from a turbo 420A. Could that have anything to do with it?
Any help appreciated. :scratch
(Also when I turn on the car I get this sound from the tranny that sounds like marbels in a dryer tumbling around)
 
WRX>2GNT
|
2849, RE: Sound from tranny
Posted by grain, May-27-04 03:53 AM
Originally posted by Jasvb TS2K2
I need some help with a wierd issue. I had a tranny swap. After the swap it has not been right. It's a stock tranny but I get this thump in 1st and 2nd gear but not anymore after that. No issues on the highway. And it doesn't happen all the time. If I come to a stop and don't make a full stop and accelerate again it does it. If I am in the gear and accelerate it happens. If I am stopped, rev above 2k and slip in 1st gear, it won't do it. I know it's not a driver thing cause I'm selling the car and it has happend to all the potential buyers that drive it. And it's been a major issue to not been able to sell it. I had the work done at a shop but not the dealer. Should I seriously talk to them about it? The stock tranny, clutch, flywheel I got was used from a turbo 420A. Could that have anything to do with it? Any help appreciated. :scratch
that migth be the rear tranny roll bracket.
look down, amke sure all the bolts are tightened and all that good shit.
(Also when I turn on the car I get this sound from the tranny that sounds like marbels in a dryer tumbling around)
thats the tob (throw out bearing) wasnt greased enought when installed. you can drop the tranny and grease it, and it should stop, or buy a new one.
| |