Go back to previous topic
Forum nameManual Trans - NV-T350
Topic subjectRE: problems after ATX to MTX swap
Topic URLhttp://forums.2gnt.com/dcboard.php?az=show_topic&forum=34&topic_id=5714&mesg_id=5717
5717, RE: problems after ATX to MTX swap
Posted by Chamuko, Dec-31-69 06:00 PM
Its going to take you a good two bottles from a completely dry system to get most of the air out and everyting tip top.

I would second the tranny is shot argument though. Is the clutch pedal bolted down completely? so that when you push on it its just the pedal and not its base that moves? Is the master leaking at all? Are all the clips on the cables and brackets there?
I generated this page in 0.010542154312134 seconds, executing 6 queries.