5153, RE: LSDs Posted by baxsom, Dec-31-69 06:00 PM
i decided to go with the OBX LSD
for better or worse as soon as it gets here and i get it installed we will see how well it works
in addition to the LSD i am considering doing the neon tranny swap as well figured i could get the neon tranny, open it up and put the LSD in so there wouldnt be as much down time for the car
as far as i have discovered i need these parts to put the new LSD in
Speedo gear 1 4797316 Bearing Cups 2 4567022 Cone Roller bearings 2 4567025AB Mopar Trans fluid 3 4874465 Differential ring gear bolts 12 4761105 Case half sealant 1 4318083 Diff pin retainer brackets ** 2 04800059AA Axle seal 2 4797334
is there anything else i need that anyone can think of other than a tranny jack
i have 2 hydrolic floor jacks but no transmission adapter also my dad has a car lift and bearing press in his garage so getting the car in the air and pressing the new bearings in shouldnt be a problem
maybe a new rear mainseal just in case
i would like to find a good write up on how to take out the transmission since this is the first time.
i have chiltons manual but still a little nervous.
|