Does anyone have a Write-Up or Explanation of how to Replace the Input and Output Speed Sensors on the Auto Trans?
I'm pretty sure that's the Problem, atleast from everything I've read.
I'd rather try and do it myself than Pay the Shop to do it. Thanks.

What are the problems you are having?

Stuck in "Limp" Mode, no Speedometer (well it goes in Reverse), some of the HVAC Control Lights went out (but I believe that's a Seperate Problem).

there right on the outside of the transmission. you just unplug them from the harness and they unscrew. Big though like 1" or more socket. There not tight though, maybe 20 ft-lbs. If that. They sit above the silnoid pack.

Would you happen to know where to Buy the two, besides from the Mitsu. Dealer? I've read some People have got them for like less than $20 a Piece.

Did your check engine light come on?

It did come on, but I Removed the Battery Over Night and it hasn't been on since, I've only Driven it around the Block a few times though anyways.

What I would do is to let the light come on again and scan for the code to make sure that sensor is what you need to change.

Tcm doesnt turn on cel. At least in any of the 2g's I have scanned.

my cel came on for both input and output sensor.

Yeah I've Read both Sides of it.. That it either comes On, or it doesn't at all.