Any 1 got an idea how to do this I got it unbolt and screwed everywhere but wont come up cause wire is the way for od.

I think your asking how to remove the shift knob. Turn it counter-clockwise to unscrew it.

Originally posted by etx
I think your asking how to remove the shift knob. Turn it counter-clockwise to unscrew it.

I think hes an auto. I have no idea how to get an auto knob off. Never had one :shrug

i tried to remove mine but i had the same problem with the OD wire. There are a couple of screws on the front facing part of the shifter, take them off and the front pops off. after that i had a screw on the drivers side that i just screwed out to take the backing off, but i still had a problem with that OD wire and all i could think of was since it was the equivalent of wire tied to the lever, snip the tie, then relocate the button..... but i still havent found a good place for the button so i havent done this yet, hope that helps a bit

95 eclipse RS, 3" Megan racing Catback exhaust, 3" straight pipe "high flow cat" and a crappy CAI

You can use a small flathead screwdriver to pry from the top or the bottom of the button. Understand.........I only know this because after trying to get mine off and breaking it, I looked. So I'm not saying you'll get it back on, but if I had to do it all over again, this is how I would do it.