anyone running a 20g on the atx?

i think im going to order one and see how long it takes my trans to blow up...

discuss.

in that case ill keep you guys updated on how it goes :o

Guess nobody is as crazy as you ;) . Good luck }(

I bet its just fine. IMO this tranny is OK.
Im at almost 100K and not a single problem

yea, mine is holding up great on 15 psi with the 16g. alhtough im on my 2nd headgasket now.

trans is running great, and i beat on it quite a bit.

:thumbsup

Im runnin a T03/04 on the ATX

This tranny WILL break after ~300 ft.lbs. of torque. Maybe not the first couple of runs... but it WILL break. Honestly, the MTX swap is a much better mod than the 16g-20g conversion. You're already turbo'd, but the ATX is REALLY holding you back. Remember, I used to talk up the A604 all the time until I swapped. The increases are HUGE, guys... seriously. Do the swap instead.

Originally posted by dougie2
This tranny WILL break after ~300 ft.lbs. of torque. Maybe not the first couple of runs... but it WILL break. Honestly, the MTX swap is a much better mod than the 16g-20g conversion. You're already turbo'd, but the ATX is REALLY holding you back. Remember, I used to talk up the A604 all the time until I swapped. The increases are HUGE, guys... seriously. Do the swap instead.

damn, I need to remember that magic 300ft lbs of torque # when at the dyno. Was that on the stock trans or a built one? What broke on you? I plan to swap but not till after the shoot-out.

any updates??

yea its sitting in my garage. im waiting on a decent set of snap ring pliers so i can clock it 90 degrees.

it should be on by the shootout.

it should bne fine for a while.

I ran the t03/04 on 10psi for 3 almost 4 years and 40k miles.

That was my case though, everyones different.