hmm, i didnt install the washer, i dont think anyone else has either. i ended up getting rid of a lot of the stuff that was in the kit. i think all i used were the new seals/rings, springs, and drlled the holes out to the max.

getting those pistons into back into their cylinders was a pita too...


i dont remember the size of the drill bits. if you dont have the metric, just use a close SAE. i drilled mine out to the max. i think its only 3 holes you have to do. very easy. i used a 5/64 bit for holes c/d, and if i remember right the a/b holes are for the bit w/ the kit.

i would install a tranny cooler too, only a few dollars for one, and heat will kill the a604...