Well it is time to sell my car. As you can see it is a 95 Talon ESi. So lets start with the mods list......

- 4-1 Header and Downpipe, 2.25" full exhaust with HKS style muffler
- Shortram intake
- OBX Intake Manifold
- Ported TB
- Clutchmaster Clutch
- Underdrive Pulley
- Short Shifter
- White Indiglo Guages
- VHT Taillights, clear corners, black inserts in headlights
- H&R Sport Springs
- Dropzone Shocks
- F&R Strut Bars and Rear Lower Tie Bar
- AC has been removed, but still has PS

Engine only has 5000 miles on it. Freshly Rebuilt with.....

- New Carter Waterpump
- New Melling Oil Pump
- Rods Resized
- Crank Std size
- 1.00mm Oversize Pistons (Nakamoto...OEM style)
- Reman. Head with new valves, springs, retainers, 3 angle, .005" mil
- PT style Lifters/Rockers
- Factory Cams checked by machine shop
- Clevite77 Bearings with 360* Oil Ring on Mains (95 block)
- All new gaskets and seals, including a MLS headgasket (All Fel-Pro)
- MSD Coil and 8.8 Ractive Wires
- Oil has been changed regularly
- Coolant changed once and was clean
- Plugs changed and were in good condition

Interior

- Some trim pieces painted black....rest is grey
- Kenwood Excelon CD/MP3/WMA Player
- 2-6x9 2-6.5" Audiobahn Dub series component speakers
- Trunk panels are removed, but I think I still have them all


Exterior

- Paint is in decent condition
- Emblems on sides and back have been removed
- area is covered in a flat black 'primer'
- small crack on bottom of front bumper...have to really be looking
- small dent at the bottom of driverside door
- mesh in front bumper
- All can probably be easily be fixed, but bodywork isnt my thing
- It has rims, 17x7 with 215/50/17, not sure on brand

Car

- The odometer reads 112k which is the original mileage
- Transmission has about 12k on rebuild
- Front Rotors/Pads 5000 miles
- Rear Rotors/Pads 12k or so
- Most wheel studs were also replaced
- wipers are all almost new
- front wheel bearings and all balljoints new
- Battery brand new
- Ground Wire Kit

- The car needs an alingment, it needs camber kit for the front and has the DIY camber mod on the rear.

-Also available is a Barely used NX wet kit that will come with the car if I get $3000 or more, if not then it will be extra.

There is probably more that I am forgetting, but I will update it if I can think of anything else. If anyone is interested feel free to pm me, email me, or contact me on AIM. I am looking for $3200, but I am open to offers. I will have pics available, contact me if you are interested.

Thanks

P.S. I am located near Sioux City, IA 51106....for reference

Price drop to $2800 with N20.....Anyone interested??

Now on EBAY!!!