Well it is time to sell my car. As you can see it is a 95 Talon ESi. So lets start with the mods list......

- 4-1 Header and Downpipe
- Shortram intake
- OBX Intake Manifold
- Ported TB
- PD Mechanical Tensioner
- Clutchmaster Clutch
- Underdrive Pulley
- Short Shifter
- White Indiglo Guages
- VHT Taillights, clear corners, black inserts in headlights
- H&R Sport Springs
- Dropzone Shocks
- F&R Strut Bars and Rear Lower Tie Bar
- AC has been removed, but still has PS

Engine only has 200 miles on it. Freshly Rebuilt with.....

- New Carter Waterpump
- New Melling Oil Pump
- Rods Resized
- Crank Std size
- 1.00mm Oversize Pistons (Nakamoto...OEM style)
- Reman. Head with new valves, springs, retainers, 3 angle, .005" mil
- PT style Lifters/Rockers
- Factory Cams checked by machine shop
- Clevite77 Bearings with 360* Oil Ring on Mains (95 block)
- All new gaskets and seals, including a MLS headgasket (All Fel-Pro)
- MSD Coil and 8.8 Ractive Wires
- Oil has been changed 3 times and was clean
- Coolant changed once and was clean
- Plugs changed and were in good condition

Interior

- Some trim pieces painted black....rest is grey
- Kenwood Excelon CD/MP3/WMA Player
- Planet Audio 800w Amp
- 2 12" Audiobahn Subs
- 2-6x9 2-6.5" Audiobahn Dub series component speakers

Exterior

- Paint is in decent condition
- Emblems on sides and back have been removed
- area is covered in a flat black 'primer'
- small crack on bottom of front bumper...have to really be looking
- small dent at the bottom of driverside door
- mesh in front bumper
- All can probably be easily be fixed, but bodywork isnt my thing
- It has some rims, nothin special just 14's, but better than stock?

Car

- The odometer reads 109k which is the original mileage
- Transmission has about 9k on rebuild
- Front Rotors/Pads 200 miles
- Rear Rotors/Pads 9k or so
- Most wheel studs were also replaced
- wipers are all almost new
- front wheel bearings and all balljoints new
- Battery brand new
- Ground Wire Kit

There is probably more that I am forgetting, but I will update it if I can think of anything else. If anyone is interested feel free to pm me, email me, or contact me on AIM. I am looking for $4000, but I am open to offers. I will have pics available, contact me if you are interested.

Thanks

P.S. I am located near Sioux City, IA 51106....for reference

Also currently the car does not have a cat-back exhaust or the alignment done. I fully intend to have these completed shortly.
Also I am currently installing some of the interior back in, this will also be done shortly. Just wanted to make note of there things for those of you who request pictures arent surprised if it is not 100% right away.