well my bell housing has a damn window in it now...so i picked up a 3.55 tranny and need the bellhousing to swap the gear set to...i need it as cheap as possible too...thx guys


p.s look in manual trans forum for pic later.,....hehehe

You will be extremely lucky if you can find just a bellhousing. I was in the same boat as you a few months ago with a pin that pushed out through the bellhousing. I finally gave up trying to find one and spent $45 to get it helicoiled. I don't know if that'll work for you without seeing a pic, but you might want to give it a shot.

lmfao, helicoil will not fix my issue, i got a 2x2 window in my bellhousing...lol

Get it welded. =)

i have an extra bellhousing but it isnt the prettiest. The trans mount holes are stripped and poorly helicoiled and one of the shaft bearings are missing. I have searched high and low to get the correct bearing but dodge, mitsubishi and even specialty bearing shops cant seem to match it up. I ran into the same problem and i would def. get it welded.

Originally posted by greygoose
Get it welded. =)

Originally posted by taclipse
i have an extra bellhousing but it isnt the prettiest. The trans mount holes are stripped and poorly helicoiled and one of the shaft bearings are missing. I have searched high and low to get the correct bearing but dodge, mitsubishi and even specialty bearing shops cant seem to match it up. I ran into the same problem and i would def. get it welded.

Originally posted by greygoose Get it welded. =)

na cant get it welded the whole bell is gone, the differential pretty much exploded and destroyed it