The bolt on my timing belt tensioner pulley arm broke, so I'm cleaning out my garage to get some dough for the repairs. Here is what I have so far, I will be adding more as I clean it out.

Since I have it all torn apart again I'm getting a non-modular clutch installed.

Cutch is a Spec stage 3, I didn't even have it in my car long enough to break in my new motor, mabye 1000 miles tops, never launched on, all splines are good but it doesn't come with a TH bearing. Its a little scuffed from unstalling it. $250.00 + shipping but willing to take offers.

98-99 420a Eclipse MT ECU tested and working, from a 99 to be exact. Chrystler PN # P05293191AC 0529 Serial # T59EH2048A6802 $75.00 plus shipping.

OBX 4G63 Eclipse underdrive pulley, some idiot on eBay sold me this claiming it was for a 420a, so make an offer.

15 plus shipping for the pulley

Ok, I'll consider that offer. I would also like to offer some additional information on the clutch. It was new when I installed it, and 1000 miles is a high estimate. My speed sensor was broken for a little while so I estimated much higher than it probably is just to be safe.

I'll take the clutch :) its not like you abused it or anything right just some light break in driving right?

I'm in San Jose, CA 95133

its a modular clutch right?

I'm just updating this listing. I'm pretty sure the clutch has been sold, and I'm going to lower the price of the ECU down to $60.00, I just need to get some stuff outta here. Msg me if you are intrested, also the 4G63 UDP is still available for offers.