i have collected all of this stuff over the last 2 yrs when i had visions of boosting my venge, but never finished getting the last couple pieces together to finish the turbo system. so its been collecting dust at my moms house and now my dealership. and its time to get rid of this stuff.

*used* block: $125 pickup only
ive got a sohc block & crank sitting in the corner at the shop. the engine came out of a neon w/ 130k that was rear ended, before i tore it down it rotated very smoothly(roughly 10-15ft lbs torque), no visable damage on the crank or the cyl walls. still have the rods, pistons, and rod bearings fully intact. i will not serperate the block/crank assy. i was going to build it into a low comp engine but my goals have changed with the car.

*used* manifolds: $25 per half + shipping
i have 2 or 3 complete intake manifolds also sitting in a pile. they need to go as well.

*used* head: $50 + shipping
there is also a dsm dohc cyl head. i am unsure of the warpage on it, i myself did not pull it off the car, i bought it used and just haven't got around to checking to see if its still usable. still has the stock valves, springs, retianers, rockers, etc.

*new* 034 EIC: let $200 + shipping
i also have a never used 034 eic. its been sitting in the box since a group buy a couple yrs ago. all software, included wiring, instructions is still in the box, i just read the instructions once or twice.

*new* turbo manifold: $200 + shipping
this in one that Alain made a few yrs ago. its got a mitsu flange on it as well as the egt probe bung welded in. also never used. looks really good, nice thick flanges, good welds.

i have some other stuff, but im not exactly sure what else ill look through it tommarrow. i do not own a digital camera so as of yet i have no pics

i am willing to trade some this stuff away. for the following 5 spd parts swap parts, except for the tranny itself.

the block is pickup only, the other stuff i am willing to ship. all this stuff is sitting at antwerpen nissan in clarksville, md if anyone is interested in anyhting. and i feel that i must add this so i dont get someone coming by out of the blue to look at what i have(seen it happen beofre) please do not stop/call by the shop, if you would like to see anything that i have for sale, either post here or pm me before hand and we can make arrangements.
thanks guys

pics of turbo mani pleaz...

- J

let me know if the head is in good condtion!

Aggression:
i measured it against my big prybar(bad idea, but no one in my shop has a true bar and its flat as i can tell) it is slightly warped, @ .020". it should be ok, you'd have to get it machined but i think it will work out ok.

J:
my service writer is bringing in her camera tommarrow so hopefully by wednesday morning at the latest i can get pics of all the stuff.