1998 MTX ECU: $95 shipped

front and rear strut tower braces - polished aluminum with black endlinks: $60 shipped for both or $25+ shipping for each

gray autometer triple pillar: $50 shipped

alternator: $30 shipped

AFX UDP with brand new belts: $150 shipped

screamin' demon coil - 97+ only: $60 and stock coil

crane 8.5mm firewire plug wires - 25ohms resistance: $35 and stock wires

97 neon bellhousing - cable clutch, output shaft, and speedo gear: $50 obo

interested in the wires and coil.

Originally posted by brokenrodguy
interested in the wires and coil.

You have current dibs.


* I also have a set of calipers from a 1992 3KGT VR4 w/ pads if anyone is interested... B.O.

This may be a stupid question but Will the 97 bellhousing fit on a 95 block?? I think it would but not 100% sure. If it does Im calling dibs.

is the pillar the full piece or is it the kind that u have to screw onto your existing a-pillar. lmk, and also i may be interested in the strut bars. i'll let u know in the next couple days. thanks

Originally posted by totaleclipse_05
is the pillar the full piece or is it the kind that u have to screw onto your existing a-pillar. lmk, and also i may be interested in the strut bars. i'll let u know in the next couple days. thanks

its the full pillar made by autometer. sounds like a plan!

i'm interested in the rear strut bar and the vr4 calipers shipped to 95742. lmk...chris

Originally posted by 2point4
i'm interested in the rear strut bar and the vr4 calipers shipped to 95742. lmk...chris

PM sent!

if 2point4 isn't going to take the rear tower bar i will take both bars. If he does get it i still would like the front one. Thanx
Josh