I bought a pair of racing seats a while back....2 months ago and bought a pair of mounting brackets to install them into my car....but it seems that no one is making them or whatever....i was wondering if anyone had a pair of these lieing around?

depends on what seats you have....vasrious seats use different demensions. I just made a set of brackets for pushin420a..when i bought my tenzo seat i just bought the brackets because i was too busy at the time.

Terry

96 Eagle talon ESI
rear disk conversion - Niche 17" chrome shoks - Stillen front and rear sway bars - Koni yellows wrapped with eibach - Star Stage II - Optima locate in the hatch - Tenzo-R seats/4 pt harness - momo Steering wheel - Boost/oil/EGT gauges, HKS TT

Waiting to be installed: Apexi AFC, HKS EVC IV, ceramic intake, 355 neon tranny, stage 2 MIBA clutch, Power doors, 450 Turbo injectors, Adj Fuel reg/return line, Backseat eliminator kit(my design), GSX Front brakes (need rotors)

I could make them, but would need the specs off of the seat for dimensions. Are you planning on using sliders? I would also need dimensions on those.

Andy

ya they came with sliders and ill be using them...have you made the brackets before? How soon could you make them?

It would take me a week or two, I haven't made brackets before. I have fabricated other parts though. I am currently making a frame for a Mini Baja Car for the SAE competition. I am making it out of 1.25" .049" wall thickness 4130 Chromoly tubing, that stuff is tricky to weld. It is thin, so it is real easy to blow through it. I would need dimensions from you however for the mounting points.

Andy

MonteSS86@hotmail.com