All parts have about 2200 miles:

NER stage 1 turbo kit $1800 shipped
-Turbonetics T3/T04s ceramic ball bearing turbo
-NER equal-length exhaust manifold
-NER 2.75" downpipe with flex section
-Tial 35mm wastegate
-HKS Standard blow-off valve
-Vortech FMU 12:1
-Walbro 255 LPH hi-PSI fuel pump
-misc. lines and fittings
-tapped oil pan
-Joe P MBC

This kit pulls very hard! Spool up is quick with the ball bearing center section and full boost arrives about 3800-4000 rpm with cat-back and stock catalytic conveter. With these parts I ran a moddded 99 Mustang GT from a 70mph roll and was dead even with him when I shut it down at 120mph and this waS AT ONLY 5PSI and NO intercooler. There is not a doubt in my mind that this set up with a IC even on stock internals can be 13 seconds. I am flexible on the pricing cause I have to sell ASAP. PLEASE PM me with offers but don't low ball me. Thanks. Sean

Crane Cams 0014 camshafts $300 shipped
HKS Type 0 turbo timer $70 shipped
Thermal R&D 3" cat back $375 shipped
AFX UDP $100 shipped

I need to sell this stuff ASAP. I need to pay for next semester.

im PM'ing you!

Im PMing you, except add the turbo timer to my list:), so in case i cant get the UDP maybe the turbo timer will work out.

Joseph

dibs on exaust




-Tony
98'GST
92'TSI-AWD

eclipzgst@charter.net
http://eclipzgst.webhop.net
http://www.newengdsm.org/

turboclipz on AIM

"...don't make me photoshop your pants so high that your undies start going over your head, think of it as a kaptainmyke wedgie if you will" -Kap'n Myke

If you guys are interested in the parts please PM me.

hey i pm'ed you about the UDP and you never got back to me. you still selling it? its not warped or anything right?

Sorry, I thought you were the guy that just bought one from Howell. Nevermind. I still have it for sale. There is a small chip on the outer edge of the pulley. Nothing that affects its performance.