Have a red 96 Talon Esi with a rebuilt 420a. Car has too much frame rust and will not pass inspection. Motor has about 25k on it and is bored .020 over and ran strong. I don't have many details of the motor because my grandpa did it when I was 16-17 as a gift about about 4 or 5 years ago and quite frankly I don't feel like tearing it apart to look so let's just assume it's a stock rebuild. I will vouch though it ran flawlessly. Just trying to gain some interest at the moment and see if it's worth starting to tear apart. I'm located in 16057.

I'm trying to sell everything. Hood, engine, trans, hatch, interior (gray), fenders, doors, lights, etc... I've been out of the DSM scene for a bit but I'd rather make use of all the good parts on the car for you guys rather than just junk it. Let me know what you need. Car is at my buddies place right now but once I get it to my place I'll start tearing it apart and listing prices.

how much for the engine harness connector that plugs into the ecu and about 6-8" of wire connected to it?

I'd rather not cut up the engine harness at the moment but shoot me an offer and I might accept it once I get it to my house. Money talks.

Okay finally decided on what I'm doing.

Engine: Stock rebuild, bored .020 over, about 25k miles. $600

Tranny: Unknown mileage shifted fine when the car ran (electrical troubles) $250

Will sell together for $800. Will ship at buyers expense.

Shell: Frame is rusted bad so I don't recommend any use other than as a parts car. Front seats have already been sold. $600

Bump. Everything is obo.