I have build a kinda one of a kind intake manifold and see if any one is interested in it. I have three intakes right now and really do not need this. I was going to run it but have seen kinda lost the interest in it (that and my other manifold is nicer lol). It will bolt right on to the top half of the stock intake replacing the small pleanum. Very easy install no modification to anything. I will also include a fel-pro gasket for it to mate to. Also is all set up for a jeep 60mm throttle body. The picture is of it before it was done. It is sitting on a shell at work collecting dust I can take more pictures of it if people would like to see. I would be asking 125 shipped to the 48 inland states or 100 picked up in Oceanside CA.

Hi,

Few questions:
Do you have any pics of it mounted on an engine?
Can you access the fuel/injectors rail with it mounted?
Does it have a place for the stock map sensor?

Thanks,
Ivan

I do not have any of it installed. I had it test fitted to a stock lower half you should have a no huge problem with getting to the fuel injectors from the way it looked. As for the map sensor I have drilled a spot of it on the back of the manifold for it.