Go back to previous topic
Forum name2GNT Buy / Sell / Trade (BST)
Topic subjectFS: Quaife LSD, 3.55 trans, Spec 5 clutch, DSS stage 2 axles, cyl head , mechanical timing set (Alexandria, MN 56308)
Topic URLhttps://forums.2gnt.com/dcboard.php?az=show_topic&forum=i16&topic_id=117809
117809, FS: Quaife LSD, 3.55 trans, Spec 5 clutch, DSS stage 2 axles, cyl head , mechanical timing set (Alexandria, MN 56308)
Posted by Jungy, Jun-08-10 06:52 PM
All items are out of the car and ready to ship, all prices are OBO.

3.55 trans w/ quaife lsd (2500 mi rebuild when lsd installed) - $750+ship
Quaife lsd w/o trans - $650


Spec 5 clutch, tons of life left, modular with stintered iron disc (750 mi) - $150



Drive shaft shop stage 2 axles, pass side was ground down a little but never caused any probs (2500 mi installed with new trans and quaife) - $250


Cylinder head, complete minus cams, includes sbi lifters and rockers otherwise all stock - $150


Mechinical timing conversion kit includes new mech tensioner, new idler, and new gates racing belt - $115
117816, RE: FS: Quaife LSD, 3.55 trans, Spec 5 clutch, DSS stage 2 axles, cyl head , mechanical timing set (Alexandria, MN 56308)
Posted by mitsu95023, Jun-09-10 03:12 PM
pm sent on quaife and mechanical tensioner setup
117818, RE: FS: Quaife LSD, 3.55 trans, Spec 5 clutch, DSS stage 2 axles, cyl head , mechanical timing set (Alexandria, MN 56308)
Posted by Slo2g, Jun-09-10 07:30 PM
If you still have the axles in a couple of weeks I'll pick them up!
117819, RE: FS: Quaife LSD, 3.55 trans, Spec 5 clutch, DSS stage 2 axles, cyl head , mechanical timing set (Alexandria, MN 56308)
Posted by Jungy, Jun-10-10 08:31 AM
Head and axles sold! All PM's replied.
117823, RE: FS: Quaife LSD, 3.55 trans, Spec 5 clutch, DSS stage 2 axles, cyl head , mechanical timing set (Alexandria, MN 56308)
Posted by Jungy, Jun-10-10 07:28 PM
Clutch sold!
118000, RE: FS: Quaife LSD, 3.55 trans, Spec 5 clutch, DSS stage 2 axles, cyl head , mechanical timing set (Alexandria, MN 56308)
Posted by streetlightning, Jul-08-10 10:46 AM
Ne update? Pmd about the crank scraper and windage tray. Thanx