I have a head that is almost finished. it has a mild port and polish. it is otherwise stock with 120,000 miles on it. I never had a problem with it just replaced it with a built head. I am putting new valve seals in it even though they were fine. comes assembled with stock cams and everything torque to spec. I also have a stock intake manifold that I gasket matched the ports on the runners. asking 350 obo for the head. make offer for manifold. the head will be finished later this week which then I will take pics. I just wanted to get it on here for people to see. thank for looking
cameron

Originally posted by halfasss101
comes assembled with stock cams and everything torque to spec.

Hmm... in order to torque the head to the motor your buyer will have to remove everything. Why are you torquing everything down before it is installed?

o yes that's right. forgot about that part. I've only done this head a couple times and forgot the cams were in the way on this particular head

Also has the head been checked for straightness? It'd be great if the head was ready to go but in my experience I have never removed an aluminum head that didnt warp upon removal.

the shop said they checked it. but I am going to take a straight edge and a level to it tonight to make sure

I checked the head surface. it is good

$350 shipped?

Pics will be up tomorrow for sure.

Finally got the pics up so here they are.

<a href="" target="_blank"><img src="" border="0" alt="Photobucket"></a>

<a href="" target="_blank"><img src="" border="0" alt="Photobucket"></a>

<a href="" target="_blank"><img src="" border="0" alt="Photobucket"></a>

<a href="" target="_blank"><img src="" border="0" alt="Photobucket"></a>