Sorry for the multiple posts.

This is a combination thread. Please delete the other threads.

Megasquirt 1 ver 2.2 board $195

Built and worked on over the years by starturbotalon. I used 029v firmware and wasn't able to get the 4g63 igniter to work for both ignition circuits. Terry used 029y firmware and said it worked fine. Either way it is a great fuel only computer. 3 bar map installed. Black case with one screw that is broke off in the case in one of the 4 threaded anchor holes. Not a big deal but I like to be as descriptive as possible. Does not include the harness.

I can answer questions after the sale about its history but I cannot offer any installation or tuning advice. That would be better left to the pros here on the board. Pinouts are standard as seen here on the board.

I have two stock pieces that I had chromed that I used for a couple years and have since removed from my engine bay.

Power steering bracket looks great. Professionally dipped and is a rare find. $40 plus shipping. I think the chrome cost me more than that.



Also I have a ECU bracket that came in an automatic 2gnt (wide enough for a stock ecu and trans ecu). The was dipped on the outside but not inside. The inside has some build up that can be cleaned and the top flap is not chromed on the top. Still looks great. $40 plus shipping.

Hayame power steering dress up capRare piece. I will throw in the stock cap for good measure

$25 plus shipping

The cap is showing some signs of heat stress around the Hayame label and isn't perfect.

Stock power side mirrorsI am sure they can use to be painted if you are going to nit pick them.
Power mirrors worked well when removed from my car. Stock black color.
$40 plus shipping.

Real carbon fiber splitters-are not ebay specials. They are made from very thick carbon fiber.$50 OBO plus shipping.


(3) 1995 ECU's $75 ea

1st ECU P/N P5269730

2nd ECU P/N P 04874191
Says software updated old P/N 05269730

3rd ECU P/N P5269656