I am selling this mock up Tubular Exhaust Manifold that I made. I used this first one to mainly mock up my design to ensure it would fit correctly. It is MIG welded. All it needs is a collector and a flange and its good to go. It is SCH10 304 stainless piping with a mild steel 420a flange. All piping is 1.5" ID. Note: If you are using stock radiator/fans, you will need to relocate the fan on the p/side to the front of the radiator. Depending on the size of the turbo you are using, you may need to also relocate the d/side fan as well, but only if your using anything bigger than a 60-1 (this is not for sure, just an guestimate). I am selling this manifold for mainly only what I have in material and 5-7 hours of labor in. $230 shipped gets it. I am guessing that no one will probably buy it because it does not have a collector on it, but they are not that hard to make, or even to have a local muffler shop make for you. I started to grind some of the welds down so they were smooth with the piping, but decided I was going to sell this one, so I did not finish them. I will finish them for an extra $50 or you can do so yourself or even leave them be, its up to you. If needed, I can supply a t3 flange for an extra $40 as well that is stainless steel. If I get no interest by Wednesday, it will go on ebay.
Note: the 90 degree elbow that is not pictured in these pics is on now and welded, everything is welded and ready to go like I said, just needs a collector and a flange.

URL=http://imageshack.us]
http://imageshack.us>
http://imageshack.us>

Bump, only $200 shipped guys!

bump. will do $165 shipped guys. you do realize you would be one of the only ones with a badass manifold like this! shops would charge $500+ to make one of these suckers!

PM sent y0

Originally posted by XMasta19
PM sent y0

replied :)

Originally posted by eclipse982nrRST

Originally posted by XMasta19 PM sent y0

replied :)

x2 yesssss

Originally posted by XMasta19

Originally posted by eclipse982nrRST

Originally posted by XMasta19 PM sent y0

replied :)

x2 yesssss

replied again :)

bump, someone buy this beast

What is the difference in height from the top of the manifold flange to the highest point on the pre-collector 180* bends?

Originally posted by DarkOne
What is the difference in height from the top of the manifold flange to the highest point on the pre-collector 180* bends?

i will let you know tomorrow. i have it up at my shop so i will take some measurements for you and PM you Dino.

Originally posted by DarkOne
What is the difference in height from the top of the manifold flange to the highest point on the pre-collector 180* bends?

PM sent to you Dino!

Hello,
I was wondering if you still have your manifold for sale?
I am very interested and i could paypal you the $165 right now for the manifold.
Thank you,
Brendon Jongeward

Originally posted by Jungy
Hello, I was wondering if you still have your manifold for sale? I am very interested and i could paypal you the $165 right now for the manifold. Thank you, Brendon Jongeward

PM'd. Manifold Pending payment.

SOLD