Yeah, I also am going NA, as far as my budget will allow, hopefully I'll have a little surprise for you at this years shoot out Todd...

I have a great set up in mind, now it's just a matter of when my bedget will allow me to build it. Also last step of mine will be pulling the motor. At which point idecide on high cmopression 2.2L stroker (Howell soon to be) or 2.4L swap...

And Todd I was wrong I won't be playing with timing soon... :-( So now seriously looking at the S-ITC, at this rate I may have one installed before you :-)

"The fastest draw is when the sword never leaves the scabbard,
The strongest way to block, is never to provoke a blow,
And the cleanest cut is the one withheld."



Michael J. Kulaga
e-mail: Michael_97RS@2gntDSM.zzn.com aol IM: MJKulga
http://highlander.dsmpower.com/

Injen CAI, 55mm TB, Hooker 4-1 Stepped Header, GS-T Muffler, AFX UDP, S-AFC, 8.5mm Magnecor Wires, SS Clutch Line, NRG Susp. Motor Mount Ins., FU/RU/RL STBs, TSW Blade 17x7.5, Bridgestone Potenza RE730 215/45ZR-17. Front KVR Cross-Drilled Rotors and Carbon Fiber Pads

To Be Installed: Ported/Polished Intake Manifold 1/2, Rear disc brake conversion kit, SS Brake Lines, Rear KVR Cross Drilled Rotors and KVR Carbon Fiber Kevlar Pads, Crane Ignition Amp