Before a huge undertaking, I need to know if I can drop speaker wires through to factory tweeter holes and be able to grab or reach them from under the dash. If not, will I have to remove the dash?
these are component tweets that lead to crossovers, therefore I need to run the wires.
thanks
Luke

^^its easy. pop the factory tweets out w/ a flathead covered w/ a piece of thin cloth (so that if you slip you wont put a tear in the dash). wrap electrical tape around the end of the speaker wire so that it comes to a "point" (just to help it slip through any obstructions). lower it in a few inches with one hand and reach up from underneath w/ the other. if you cant feel it, use a flashlight. its really not that hard, trust me. :thumbsup

just what i needed, thanks!