Are there any spots on the firewall that I can run wires thru to my interior? I looked around but didnt see any where not even those lil black pieces of rubber that cover up the hole. I own a 98' GS if there was any difference in the years on what they did to the firewall.

Thanks In Advance

steering boot

On the passenger side there is a big one on the firewall. I ran 2 4AWG power wires through it. It was easiest for me to run a coat hanger into the interior through the grommet, and pull the wires into the engine compartment. I also have a 98 GS.

Andy

http://home.att.net/~xmethodx/eclipse check the how to's thats how i ran mine. if your GS is auto there should be one up on the driver's side

I think the gromet is in the same place on 2g's, pass side lower area. I slipped an odd and 4 gauge wire through while the stcok wires where still run - WD40 is great!
If all else fails, drill a hole yourself! I have 3 holes that were drilled since mid summer, no problems yet! :7


Undergoing MAJOR modifications, inside and out
member# 2498 / girl member# unknown

How low is it.. I have been looking all over and it is really not visible in the engine compartment. Do I need to crawl under my car to see it?

its down lowjust to the left of the intake manifold. Also if you look Under the dash on the passenger side you will see a whole bunch of wires coming in to the car through a large grommet.

ya, run the wires from the passenger compartment through to the engine bay. its much easier that way, as you can easily spot and draw up the wires from the engine than trying to feed them in vice versa.

I concur with SPL....I did same thing here.

Works great.

How did everyone get the fuse and fuse cover through. I didn't know how to get around that without cutting the wire and putting it back together once it was through the firewall. This may decrease the performance of the power wire, etc. Any thoughts???

run the wire from the other way around maybe? (engine--->firewall--->passenger area)

im assuming you are using a thinner wire that has the fuse perminatly attached?

if so, use a knife to puncture and open a hole big enought to accomidate the wire. then use another piece of wire (or whatever you think would work) and run it from the passenger compartment to the engine bay via the grommet. once you can reach it in the engine bay, use a lot of electrical tape to attach it to the power wire you want to run. go back to the passenger compartment and pull on the "fishing" wire. when you see the perminante wire come through the grommet, take off the tape and get rid of the fishing wire. you can then pull the rest through by hand.