| Go back to previous topic | | Forum name | Audio, Alarms, AV | | Topic subject | Window module install....Power window wires?? | | Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i10&topic_id=6204 |
6204, Window module install....Power window wires??
Posted by jasonhko, May-21-03 07:02 PM
ok, I got a window module to close the windows when I arm the alarm. Now I wanna know what wires on the driver side window control i have to tap into? I know I have to connect 2 wires to each switch, but what color are the wires that I am looking for? I have a 99 GS, I was looking at the power windows schematics but it doesn't make sense to me at this point. ANy help would be greatly appreciated since I have my intire door trim and kick panel out of my car now.
|
6278, RE: Window module install....Power window wires??
Posted by MCubed45, May-31-03 02:57 PM
it really depends on how the stock system is setup... all my power stuff is aftermarket so i'm not too sure about the stock power windows. if you're supposed to hookup two wire for each window, it might not even get hooked up at the switch. it might be at the relay. if the stock switches work by sending a signal to the relays that control the windows then you're not going to be tapping in at the switches most likely. you'd probably tap into the relays that send power directly to the windows. it's also possible that the stock system does NOT use relays in which case you would be tapping in at the switches...
sorry, i know that made it a lot more confusing... anyone have the link to the schematics for the windows?
do you know what the outputs from the window module are? that'd help a lot. is it a +12v output or ground? how many outputs are there?
-marc
='95 RS 5spd Red=
Matrix CAI
A'pexi Turbo N1
Hanabi 8000k HID
SPAL Deluxe Power Windows
Nakayama GT5 17's
Ractive STB
GSX Calipers
AEM Rotors
255 is fricken short
| |