ok so i bought some 6x9 audiobahns from ebayand i dremeled the shit out of the rear pods to get them to fit but when i went to mount them the magnet was too big and the damn thing wouldnt fit i jimmied up a way to get them to stay on with only two bolts instead of three but the damn panel wont fit so i'm f'ing screwed basically what i wanna know is has this happened to anyone else and what the hell can i do about it i was thinking since i dont have back seats just to go to walmart get sum 6x9 enclosures and sumhow make sum cool fiberglass amp rack with the 6x9 in there some how but yea i gotta figure out sumthing soon so please help me out guys

haha, same thing happened to me, bought a pair of 6x9 infinities and after cutting the shit out of the speaker holders the magnets didn't fit. I returned the speakers and bought replacement spear pods from satan for like $40 each!

But, I have heard that other people have just took a mallet to the metal and banged it away from the magnet (too extreme for me). You could also try to use an insert to increase the speaker holders' heights (I had cut to much of the pod in order to get the speaker to fit to attach anything to it).

what speakers did you guys buy, so those of us that have yet to get some, don't make the same mistake???

Every speaker has different depth measurements but I had good luck with my infinity's. They were real close. In fact I had to remove a little of the tar paper/sound deadner thats there to get them to fit but they did.

Which model infinities I have some 6x9 infinities that I had mounted in the deck, but when I replaced those with my 6x9 subs, I was going to moveinfinities to the pods. BUt then heard everybody who had infinities not making it.

I have Infinity Kappas, a couple years old or so, green cones.



15.9 @ 86.7mph

Injen CAI, 55mm TB, P&P Intake, Crower Cams, Hooker Header, ERT/Catco Cat, GS-T Muffler, AFX UDP, Crane Ign Amp, S-AFC

They were the new line References. All white cones.

http://forums.2gnt.com/dcboard.php?az=show_topic&forum=7&topic_id=48078&mesg_id=48078&page=

thats what i ended up doing