k so i put in a power trunk release in my car. i still hafta run the wires up front an stuff though. i have a viper esp500 alarm installed in my car an there's an open channel that i can hook up to the trunk release. the output from the alarm on that channel is marked as (-) 200mA. does that just get hooked up straight to the relay? just wonderin if i had to do anything else inbetween. i know i hafta make sure the relay handles enough amperage for the trunk release solenoid and everything. anyways, any help would be greatly appreciated. thanks!

-marc

='95 RS 5spd Red=
CAI
A'pexi N1
Hanabi 9000k HID
SPAL Deluxe Power Windows
Nakayama GT5 17's
GSX Calipers
AEM Rotors

255 is fricken short

Yes, that wire just goes to the relay. Here's how to wire up the relay if you didn't know already:

85 - negative trigger from alarm
86 - 12V +
87 - 12V +
30 - output to trunk release solenoid

Hope this helps!

Dont forget to fuse your 12 volt lead going to your relay. A 15 amp should be plenty.

cool thanks guys! just makin sure i was wiring it right. oh an i got i got the fuse for the solenoid an everything. thanks! :thumbsup