ok guys so i did my first alarm install. Time consuming but i wired everything up. The alarm works perfect. No problems but the remote start shows error. I wired the neutral safety wire to the ebrake. But there is H1/1 WHITE/BLUE (-) REMOTE START/ TURBO TIMER ACTIVATION INPUT H1/1 that i donot know where it goes to. I heard it doesnt need to be connected not sure though. please help guys

BElow is how I wired the remote start harness from the alarm to my ignition harness.

(H3) 10-pin connector
H3/1 PINK (+) IGNITION 1 INPUT/OUTPUT =Black/White ignition harness
H3/2 RED/WHITE (+) FUSED (30A) IGNITION 2 / FLEX RELAY INPUT 87 = White ignition harness

H3/3 ORANGE (+) ACCESSORY OUTPUT = Blue
H3/4 VIOLET (+) STARTER OUTPUT (CAR SIDE OF THE STARTER KILL) = Black/Red Ignition Switch Harness

H3/5 GREEN (+) STARTER INPUT (KEY SIDE OF THE STARTER KILL WIRE) = Black/Red Ignition Switch Harness

H3/6 RED (+) FUSED (30A) IGNITION 1 INPUT = White ignition harness
H3/7 PINK/WHITE (+) IGNITION 2 / FLEX RELAY OUTPUT = Blue/Black ignition harness

H3/8 PINK/BLACK (+) FLEX RELAY INPUT 87A key side (if required) of FLEX
RELAY = Cut short and tape off

H3/9 RED/BLACK (+) FUSED (30A) ACCESSORY/STARTER INPUT = White ignition harness

dont know if you ever figured this out or not, but did you connect the brake wire? the remote start system has to see this wire resting at ground to funtion. also is the hood pin connected? if so did you have the hood open? if so it wont remote start