Go back to previous topic
Forum nameAudio, Alarms, AV
Topic subjectRE: Box connect terminals melted......
Topic URLhttp://forums.2gnt.com/dcboard.php?az=show_topic&forum=10&topic_id=12856&mesg_id=12868
12868, RE: Box connect terminals melted......
Posted by 2GeclipseRS, Dec-31-69 06:00 PM
That peice of shit box is getting tossed in a little while.

I'm having a box built for four 12's soon. These subs have been sitting in my room for 2 months now doing nothing.... I'll probably sell the box and subs later for something smaller/lighter.

When i move my battery to the hatch, i'll cut a hole in the case cover for a fan, slot it so it can vent and raise it up about a 1/2 inch.

It gets hot waaaaay too quick. Now, i dont even bump hard.

1. I blew one of my kenwoods.

2. The other one is running at 4 ohms and distorts bad at anything over 25% gain.

I got around the terminals by drilling a hole just big enough for the speaker wire and haven't had any problems since. If i didn't get the box and subs for free, i wouldn't have them. They're crap.
I generated this page in 0.0068368911743164 seconds, executing 6 queries.