I'm finishing up my ms2 install and all I have left is installing my IAT sensor. I was wondering where you turbo guys have it located... I have water/meth injection about 26 inches away from the TB and was going to put the IAT right before the TB, just not sure if that would be the best spot since the meth isn't too far away... Just checking to see what some of you think. I might be getting rid of the water/meth injection down the road, but am not sure yet.
#109676, "RE: IAT sensor location" In response to Reply # 0
Either there or on the IM is fine. Will not make a drastic difference. If I recall the standard operation MS controlling w/m disables the IAT during spray anyway. Unless you manually have a secondary spark map.
#109677, "RE: IAT sensor location" In response to Reply # 1
I spray meth just a few inches before my AIT sensor in the intercooler pipe. It would depend on how you have your MS configured, I use the regular output functions to control meth so it doesnt disable the IAT while spraying.
