#109423, "Got turbo kit installed, fired up, backfiring out the turbo/dp bad!"
Well... after a few weeks of fun, the turbo kit is finally all installed. For now, I'm running without any exhaust. Engine turned over and started up but idles a bit rough. It'll stay running fine but it backfiring pretty badly out out the exhaust (which is just the turbo at the moment).
Idle fuel pressure is about 50 psi using Vortech 12:1 FMU with stock injectors right now.
Adjustable cam gears are both at the 0 mark.
Head is stock, bottom end is 8.8:1 compression.
Hmm... now that I think about it, I don't have any o2 sensors connected (since I don't have the exhaust on yet). Would that cause the problem? I pretty new to this, but any advice/info would be great. I can throw the downpipe and stock o2 sensor on it if need be.
Anyone know anyone who can help me tune this in the Pittsburgh area (Greensburg)?
#109432, "RE: Got turbo kit installed, fired up, backfiring out the turbo/dp bad!" In response to Reply # 2
That was indeed the issue. Seems to idle pretty decent now and no more backfiring. Now to get all the damn gauges installed and electronic stuff in place.
Anyone know anyone who can help me tune this in the Pittsburgh area (Greensburg)?
#109440, "RE: Got turbo kit installed, fired up, backfiring out the turbo/dp bad!" In response to Reply # 3
It runs better now, but I'm wondering if I'm getting fuel cut or something. Once I hit around 4000 rpms and it should be building boost, the car like dies... seems like it bogs down bad and has no power. I'm still in the process of getting things hooked up and even after adding a 3-wire FCD, which seemed to make no difference, it's still doing this. Any thoughts?
Anyone know anyone who can help me tune this in the Pittsburgh area (Greensburg)?
#109446, "RE: Got turbo kit installed, fired up, backfiring out the turbo/dp bad!" In response to Reply # 5
Originally posted by eclipse420ags sounds like bad boost leak.
Hmm.. could be. Didn't really think about that. I still need to get the boost gauge connected properly. For testing purposes, I tried connecting it T'd into the line going from the wastegate to the compressor housing but it didn't seem like I was building boost just revving in neutral. Should I be able to see anything on the boost gauge revving to about 4-5000 rpm in neutral? Maybe I don't have something connected properly? I was a little confused about some of the boost lines.
Anyone know anyone who can help me tune this in the Pittsburgh area (Greensburg)?