#43653, "RE: in detail wet kit install" In response to In response to 1
You use a fitting into the test port to tap off the rail unless you dont have one (you should). The instructions are detailed enough once you recieve the kit. We'd just tell you the same thing. It tells you how far to mount the nozzle and where to hook up the lines and solinoids too. All I can tell you is to use loctite blue 242 where it requires teflon paste (instructions will tell you that too).
Since I cant use photopoint IMAGINE THIS: Star turbo with E-trim and HKS BOV Starion FMIC/2.5" piping Joe P MBC Apexi SuperAFC Ross Pistons/total seal rings Ported and matched intake manifold AFX 55mm TB, FMM and UDP 2.5" downpipe back exh/Hayame muffler Crane wires/Denso Iridium plugs Centerforce DF clutch KYB AGX struts/ST springs, UPR FSB, F&R camber kits 17" ADR lightnings/toyo FZ4 215/45/17 97' eclipse front end/projectors Autometer gauges Panasonic head unit/ Sony X-over MB Quarts all around/JL stealth sub Hifonics/MTX Thunder amps XX brand alarm/Varad hyper green led
Stan2gnt Stan2va@aol.com 95 Talon 420A-Turbo Former and future nitrous user
:farfrommugen: Yes I still own a 2gnt. Damn right I've been here longer than U klassic_liven@yahoo.com