Jesus Christ you guys.


Take off your rear hatch cover.
Remove all of the bump stops and pull off the carpet.
Use a putty knife to scrape away any remaining residue from the glue or any pieces left stuck to the wood.
Sand it down.
Paint on a coat of resin.
Lay over your sheet of carbon fiber and use a roller tool to make sure it's fitted into the curves.
Paint on a second coat of resin.

Let cure.

Trim and sand the edges.

Sand the surface to get it even, then wet sand it smoothe.

Clear coat it.

Then buff that bitch down.



I haven't done it yet but it's not that fuckin hard to do. If you get the concept of laying vinyl or carpet it's just the same but with a couple extra steps and materials.