Decided to start a new thread dedicated to this pain in the pee whole to not clog the build thread.
So here is where I currently am.

Had to disconnect heater hoses and fuel line to drop manifold in.

Had to remove windshield wiper fluid reservoir to fit the Throttle Body (still brainstorming a way to get it all to fit).

Have removed the cruise control cable, and with the remaining throttle cable relocated it 2 holes down that I just discovered, seems to give me enough room. (will get pics up later).

Going to have to grab more wire loom because had to remove the MAP/break booster sensor from the wire route it normally followed.

Think I need to find either a connector or extra long heater hose to make sure it doesn't contact the intake manifold. These are my ideas and hopefully all goes well, things sitting so low have yet to even think about how the intake is going to work... one problem at a time right? Feel free to post ideas to help me out

97 Talon ESi 14.943@91.35MPH N/A!
"If you need someone to provide an itemized build of materials and a flowchart to walk you through every build-related question you will need to answer at each step of the process, you shouldn't be playing with cars. "-Driggs