Ok, so ive been playing wiith adjusting my clutch for the past 3 days, and yet i still can NOT loosen that freaking nut. (adjusting via rod that goes to the CMC through the fire wall).

Ive tried vice grips, the rod still turns, I tried a tiny wrench that fits the flat spots of the rod and a 12 mm wrench, just rounds crap off. WTF??? How hard is that nut to get off???

Im not sure if i am turning it the right direction, even though i try both ways. Does it tighten towards the front or rear of the car? And any other help would be nice, my tranny shifts bad and first gear grinds a little going in. Friction point is almost 3/5's the total distance, waaay too far off the floor.