your slave cylinder is probably shot man. Input shaft bearing?

I don't know what you mean by that. There are a couple 'input shaft bearings'. One, is right there behind that plate on the driver side of the tranny, along with the same sized output shaft bearing. Then, there is an input shaft bearing/plastic seal thing on the bell housing. Then, there is the output shaft bearing in its own race on the bell housing. Are you sure its red? Check your slave cylinder IMO. But as far as tranny fluid leaking thru there, that would be new to me. but im a noobie.

Having Problems? Heres my Three step solution to anything 2gnt related.
Step 1: Put down everything in your hands.
Step 2: Grab a lucky strike, Smoke it.
Step 3: Walk to the fridge, double fist some keystone ice, sit down in the shade, drink one beer, finish cigarette, drink other beer, roll a joint, smoke it, walk back to your problem, and in about 5 minutes the solution will come to you.
If not. Go here: here

If still nothing, your trying to hard. Start over at step 1.